USE VELCTRO TAPES

USE YOUR BASIC SCREW SET

RESET TO FACTORY SETTINGS

STEP 1: Press and hold MODE, and press ON.
STEP 2: Power ON. Your Neon Sign should be at 50% brightness.
STEP 3: Press SPEED/BRIGHTNESS- 3x in 5 seconds. Your Neon Sign will be at 25-10% brightness, flash 3 times and return to initial state.

Code should be cleared and the receiver can be controlled by any same remote.

___

PAIRING YOUR REMOTE AND DIMMER BOX

STEP 1: Press and hold MODE, and press ON. Your Neon Sign should be at 50% brightness.
STEP 2: Press SPEED/BRIGHTNESS- 3x in 5 seconds. Your Neon Sign will be at 25-10% brightness, flash 3 times and return to initial state.

Pairing should be successful and the receiver can be controlled by that remote only.